The Baby Bath Gate™ is the bath time safety gate that protects babies from injuring themselves on the faucet and fixtures by completely walling them off. The Baby Bath Gate™ is an instant barrier that prevents the burns, bruises, scrapes, and chipped teeth that occur when the faucet and fi xtures are within baby’s reach. The Baby Bath Gate™ is the only faucet guard that allows Mom and Dad full access to the fixtures and faucet while at the same time protecting baby from them. No assembly is required, it installs in seconds and is unmovable by baby.

The Baby Bath Gate is simple to use, installs quickly, requires no assembly and fits standard tub widths of 19-26 inches.

Unique Technology and Innovative Features:  The Baby Bath Gate has several unique technological and engineering features. The two adjustable, self-locking rod assemblies are made of extruded and injection molded engineering plastics that are lightweight and extremely sturdy. The rod ends swivel and self-adjust to standard tub angles, enabling the specialized non-slip elastomeric pads to hold the gate firmly in place. The vinyl coated polyester mesh of The Baby Bath Gate is tear, shrink and mildew resistant.

Features & Benefits:

• Innovative, patent pending design
• Lab-tested technology holds it secure (no suction cups are used)
• Instant installation
• Fits all standard tubs
• Rolls up for storage and travel
• Unmovable by baby

Installation:

To Install: Wet rubber ends of rods. Place The Baby Bath Gate at least 12 inches from the faucet and as close to the tub bottom as possible but above the bottom curve of the tub. Secure the top rod first by holding onto the rod with one hand while twisting the twist grip with the other hand. Twist until snug. Do not over tighten. Repeat this step with the lower rod. Center the mesh. All four rubber ends must be flush against the sides of the tub. Test your installation by gently tugging on the bath gate. Install as low on the tub sides as possible but above the bottom curve of the tub to reduce the gap between the tub floor and the bath gate. Do not allow baby to slide under the bath gate. Do not leave your baby alone in the bathtub with the bath gate. You should be able to touch your baby at all times.

To Remove: Untwist each twist grip. Remove after each use to extend the life of the grip pads.

To Clean: Untwist rods to completely separate. Hand wash with warm soapy water and rinse as needed. Allow to air dry.